Overview - HEIDENHAIN TNC 620 User Manual

Setup | Using a 3-D touch probe (option 17)

Overview

The following touch probe cycles are available in the Manual
operation mode:
Refer to your machine manual.
The control must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
HEIDENHAIN only gives warranty for the function of the
probing cycles if HEIDENHAIN touch probes are used.
Soft key Function
Calibrating the 3-D Touch
Probe
Measuring a 3-D basic
rotation by probing a plane
Measuring a basic rotation
using a line
Setting the preset on any
axis
Setting a corner as preset
Setting a circle center as
preset
Setting the centerline as
preset
Touch probe system data
management
Further information:
Manual
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Page
203
213
210
217
218
219
222
See Cycle
Programming
User's Manual
Cycle Programming User's
5
195