MOD functions | Setting the unit of measure
9.6
Setting the unit of measure
Application
With this MOD function, you can determine whether the control
coordinates are displayed in millimeters or inches.
Metric system: e.g. X = 15.789 (mm), the value is displayed to 3
decimal places
Inch system: e.g. X = 0.6216 (inches), value is displayed to 4
decimal places
If you would like to activate the inch display, the control shows the
feed rate in inch/min. In an inch program you must enter the feed
rate larger by a factor of 10.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
9
335