Checking The Cycle; Run A Graphic Simulation Of The Program - HEIDENHAIN MANUALPLUS 4110 Manual

Preparing program execution

Checking the cycle

The cycle parameters are displayed if you place the cursor on the cycle. Check the program
before running it.

Place the cursor at the
beginning of the program:
Press the Program start
soft key

Place the cursor on the
cycle:
Press the arrow key

Run a graphic simulation of the program


Place the cursor at the
beginning of the program:
Press the Program start
soft key

Press the Graphics soft key
HEIDENHAIN MANUALplus 4110 Executing Programs 11.3