HEIDENHAIN TNC 620 User Manual page 38

1
The new user administration enables you to create and
administrate users with different access rights, see "User
administration", Page 402
The new Component Monitoring software option enables
automatic checking of defined machine components for
overload, see "Additional status displays", Page 66
With the new HOST COMPUTER MODE function, you can turn
command over to an external host computer, see "Permitting or
restricting external access", Page 340
With the State Reporting Interface (SRI), HEIDENHAIN
provides a simple and reliable interface for acquiring the
operating states of your machine, see "State Reporting Interface
(option 137)", Page 374
The basic rotation is taken into account in the Manual
Operation mode, see "Activating manual tilting:", Page 228
The screen layout soft keys were adapted, see "Modes of
operation", Page 61
The additional status display shows the path and angle
tolerances without Cycle 32 being active, see "Additional status
displays", Page 66
The control checks all NC programs for completeness before
machining. If you attempt to start an incomplete NC program,
the control aborts with an error message, see "Data transfer to
or from an external data carrier", Page 82.
In the Positioning w/ Manual Data Input operating mode, you
can now skip NC blocks, see "Skipping NC blocks", Page 247
Two new tool types have been added to the tool table: Ball-
nose cutter and Toroid cutter, see "Available tool types",
Page 148
The appearance of the
changed, see "Optional program-run interruption", Page 246
You can use the key between PGM MGT and ERR to toggle
between screens.
The control supports USB devices with the exFAT file system,
see "USB devices on the control", Page 81
If the feed rate is less than 10, the control also shows one of
the decimal place that have been entered, see "Entering values",
Page 175
If a touchscreen is used, the full-screen mode is automatically
terminated after five seconds, see "Additional tools for
management of external file types", Page 86
In Test Run operating mode, the machine tool builder can define
whether the tool table or the expanded tool management is
opened.
The machine tool builder defines which file types you will
be able to import when using the ADAPT NC PGM / TABLE
function, see "Importing a file from an iTNC 530", Page 85
New machine parameter CfgProgramCheck (no. 129800) for
defining settings for the tool usage files, see "List of user
parameter", Page 453
Modified functions 81760x-06
Further information:
Programming or ISO Programming
38
Optional program run stop
User's Manual for Conversational
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Fundamentals | Control model, software and features
has