Measurement Of Machining Time (Option 20) - HEIDENHAIN TNC 620 User Manual
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (546 pages)
Table of Contents
Advertisement
6
6.2
Measurement of machining time
(option 20)
Machining time in the Test Run operating mode
The control calculates the duration of the tool movements and
displays this as machining time in the test run. The control takes
feed movements and dwell times into account.
The time determined by the control is only of limited value for
calculating the machining time because it does not take any
machine-dependent time intervals (e.g., for tool changes) into
consideration.
Proceed as follows to select the stopwatch function:
Select the stopwatch function
Select the desired function by soft key, e.g.
saving the displayed time
Soft key
Stopwatch functions
Save the displayed time
Display the sum of saved time and displayed
time
Clear the displayed time
Machining time in the machine operating modes
Time display from program start to program end. The timer stops
whenever machining is interrupted.
242
Testing and running | Measurement of machining time (option 20)
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Advertisement
Table of Contents
