Saving Presets In The Table - HEIDENHAIN TNC 620 User Manual
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (521 pages)
Table of Contents
Advertisement
5
Saving presets in the table
Refer to your machine manual.
The machine tool builder can disable presetting in
individual axes.
The machine tool builder can define a different path for
the preset table.
The preset table has the name PRESET.PR, and is saved in the
TNC:\table\ directory by default.
PRESET.PR is editable in the Manual operation and
Electronic handwheel operating modes only after you have
pressed the CHANGE PRESET soft key. You can open the
PRESET.PR preset table in the Programming operating mode but
not edit it.
There are several methods for saving presets and basic rotations in
the preset table:
Manual input
Using the touch probe cycles in the Manual operation and
Electronic handwheel operating modes
Using touch probe cycles 400 to 402 and 410 to 419 in
automatic mode
Further information:
Operating notes:
In the 3-D ROT menu, you can specify that the basic
rotation is also effective in the Manual Operation
mode.
Further information:
Page 228
When presetting, the positions of the tilting axes
must match the tilted situation.
The behavior of the control during presetting
depends on the setting in the optional machine
parameter chkTiltingAxes (no. 204601).
Further information:
PLANE RESET does not reset the active 3-D ROT.
In row 0 the control always saves the preset that
you most recently set manually via the axis keys or
via soft key. If the preset set manually is active, the
control displays the text PR MAN(0) in the status
display.
Copying the preset table
Copying the preset table into another directory (for data backup)
is permitted. Write-protected lines are also write-protected in the
copied tables.
Do not change the number of lines in the copied tables! If you want
to reactivate the table, this may lead to problems.
To activate the preset table copied to another directory you have to
copy it back.
If you select a new preset table, you need to reactivate the preset.
184
Cycle Programming User's Manual
"Activating manual tilting:",
"Introduction", Page 194
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
Setup | Preset management
Advertisement
Table of Contents
