View - HEIDENHAIN TNC 620 User Manual

Testing and running | Graphics (option 20)
Showing the tool paths
The control displays the following types of movement:
Soft keys Function
Movements at rapid traverse and at the
programmed feed rate
Movements at the programmed feed rate
No movements
If you move at rapid traverse inside a workpiece, both
the movement and the workpiece is shown in red at the
respective location.

View

The control provides the following views:
Soft keys Function
Plan view
Projection in three planes
3-D view
Projection in three planes
The simulation shows three sectional planes and a 3-D model,
similar to a technical drawing.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 10/2018
6
237