Enable Or Disable Automatic Scrolling Through The Display Variables; Enable Or Disable The Display Backlight - Emerson Micro Motion 2700 Configuration And Use Manual

5.1.5 Enable or disable automatic scrolling through the
display variables
Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Variable Menu Features > Auto Scroll
Overview
You can configure the display to automatically scroll through the configured display
variables or to show a single display variable until the operator activates Scroll. When you
set automatic scrolling, you can also configure the length of time each display variable is
displayed.
Procedure
1.
2.
5.1.6

Enable or disable the display backlight

Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Display > Backlight
Overview
You can enable or disable the display backlight.
Configuration and Use Manual
OFF-LINE MAINT > OFF-LINE CONFG > DISPLAY > AUTO SCRLL
ProLink > Configuration > Display > Display Options > Display Auto Scroll
Device Tools > Configuration > Transmitter Display > General
Enable or disable Auto Scroll as desired.
Option Description
Enabled
The display automatically scrolls through each display variable as specified
by Scroll Rate. The operator can move to the next display variable at any
time using Scroll.
Disabled (de- The display shows Display Variable 1 and does not scroll automatically. The
fault) operator can move to the next display variable at any time using Scroll.
If you enabled Auto Scroll, set Scroll Rate as desired.
The default value is 10 seconds.
Tip
Scroll Rate may not be available until you apply Auto Scroll.
OFF-LINE MAINT > OFF-LINE CONFG > DISPLAY > BKLT
ProLink > Configuration > Display > Display Options > Display Backlight On/Off
Device Tools > Configuration > Transmitter Display > General
Configure device options and preferences
81