Configure Process Measurement; Configure Mass Flow Measurement; Configure Mass Flow Measurement Unit - Emerson Micro Motion 2700 Configuration And Use Manual

4

Configure process measurement

Topics covered in this chapter:
•
•
•
•
•
•
•
•
•
4.1

Configure mass flow measurement

The mass flow measurement parameters control how mass flow is measured and reported.
The mass flow measurement parameters include:
•
•
•
4.1.1

Configure Mass Flow Measurement Unit

Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Measurements > Flow > Mass Flow Unit
Overview
Mass Flow Measurement Unit specifies the unit of measure that will be used for the mass flow
rate. The unit used for mass total and mass inventory is derived from this unit.
Procedure
Set Mass Flow Measurement Unit to the unit you want to use.
The default setting for Mass Flow Measurement Unit is g/sec (grams per second).
Configuration and Use Manual
Configure mass flow measurement
Configure volume flow measurement for liquid applications
Configure gas standard volume (GSV) flow measurement
Configure Flow Direction
Configure density measurement
Configure temperature measurement
Configure the petroleum measurement application
Configure the concentration measurement application
Configure pressure compensation
Mass Flow Measurement Unit
Flow Damping
Mass Flow Cutoff
OFF-LINE MAINT > OFF-LINE CONFG > UNITS > MASS
ProLink > Configuration > Flow > Mass Flow Units
Device Tools > Configuration > Process Measurement > Flow
Configure process measurement
23