Configure Discrete Output Fault Action - Emerson Micro Motion 2700 Configuration And Use Manual

Figure 6-1:
A.
B.
C.
D.
6.4.3

Configure Discrete Output Fault Action

Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Inputs/Outputs > Discrete Output > DO Fault Action
Overview
Discrete Output Fault Action controls the behavior of the discrete output if the transmitter
encounters an internal fault condition.
Note
For some faults only: If Last Measured Value Timeout is set to a non-zero value, the transmitter will not
implement the fault action until the timeout has elapsed.
CAUTION!
Do not use Discrete Output Fault Action as a fault indicator. If you do, you may not be able to
distinguish a fault condition from a normal operating condition. If you want to use the discrete
output as a fault indicator, see
Configuration and Use Manual
Typical discrete output circuit
24 V (Nom)
Ω
3.2 K
Out+
Out−
Not available
ProLink > Configuration > Frequency/Discrete Output > Discrete Output > DO Fault Action
Device Tools > Configuration > Fault Processing
Fault indication with the discrete
Integrate the meter with the control system
output.
119