Enable Or Disable Status Led Blinking; Enable Or Disable Operator Actions From The Display - Emerson Micro Motion 2700 Configuration And Use Manual

Configure device options and preferences
Procedure
Enable or disable Backlight.
The default setting is Enabled.
5.1.7

Enable or disable Status LED Blinking

Display
ProLink II
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Variable Menu Features > Status LED Blinking
Overview
By default, the status LED blinks (flashes) to indicate unacknowledged alarms. If you
disable Status LED Blinking, the status LED does not blink, whether alarms are acknowledged
or not. It still changes color to indicate active alarms.
Procedure
Enable or disable Status LED Blinking.
The default setting is Enabled.
5.2 Enable or disable operator actions from the
display
You can configure the transmitter to let the operator perform specific actions using the
display.
You can configure the following:
•
•
•
82
Not available
ProLink > Configuration > Display > Display Options > Display Status LED Blinking
Device Tools > Configuration > Transmitter Display > General
Totalizer Start/Stop
Totalizer Reset
Acknowledge All Alarms
®
Micro Motion Model 2700 Transmitters with Analog Outputs