End Codes - Omron V600 Series User Manual

End Codes

End codes are given by two hexadecimal digits.
Type
Normal
Host communications
errors
Data Carrier communica-
tions errors
Data Carrier memory
warnings
System errors
Note: Data processing has been normally completed for an error code of 7B. If communications are not
possible because of a low battery, an error response (e.g., with error code 72 will be returned.)
For more details on errors, refer to Error Lists.
p.139
End code Name
00 Normal end code
74 Polling Command received, Polling Command Check (no results)
75 Auto Command canceled before a Data Carrier was detected.
Polling Command canceled before a Data Carrier was detected.
Normal end code for a MANAGEMENT DATA CHECK/CALCULATE command or
MANAGEMENT DATA SUBTRACTION/LIMIT command (not an error)
76 Auto Command canceled after a Data Carrier was detected.
Polling Command canceled after a Data Carrier was detected.
10 Parity error
11 Framing error
12 Overrun error
13 FCS error
14 Format error
Execution status error
18 Frame length error
70 Data Carrier communications error
71 Mismatch error
72 Data Carrier missing error
76 Copy error
7A Address error
7C Read/Write Head not connected
7D Write-protected
7B Battery low warning (Replace the battery or Data Carrier.) (See note.)
76 Error end code for a MANAGEMENT DATA CHECK/CALCULATE command or
MANAGEMENT DATA SUBTRACTION/LIMIT command (verification error or
overwrite limit exceeded)
92 Antenna section power supply voltage error
93 Internal memory error
Section 5
Communications
RFID System
135
Operation Manual