Omron V600 Series User Manual page 153

I/O Specifications
● Input Specifications (RST, TRG/IN1, and TRG/IN2)
Input voltage 24 VDC +10% (including ripple)/
15% (PNP or NPN)
Input impedance 2.2 k
Input current 10 mA typical (24 VDC)
ON voltage 19 V max.
OFF voltage 5 V max.
I/O response time 70 ms max.
■ I/O Device Wiring Examples
■
Inputs
● PLC Output Unit
(e.g., C200H-OD21
or C500-OD412)
● NPN Transistor
Open-collector Output
(e.g., from a 3-wire Sensor)
● Device with contact
(e.g., pushbutton switch)
 Outputs
● PLC Input Unit
(e.g., C200H-ID212 or
C500-ID218)
● Relay
● Output Specifications (RUN, BUSY, ERROR, OUT1, and
OUT2)
Maximum switch-
ing capacity
Leakage current
Residual voltage
Note 1: The CPU will stop operation and the RST indicator will
light when the RST input is turned ON.
2: The transistor may be damaged if an output is shorted
with no load connected.
ID Controller Input Section
COM_I
+V
2.2 kΩ
RST
OUT
0 V(COM)
2.2 kΩ
TRG1/IN1
+V
Outputs
0 V
2.2 kΩ
TRG2/IN2
24-VDC
power
supply
ID Controller Output Section
RUN
COM
IN
BUSY
IN
ERROR
OUT1
OUT2
COM_O
24-VDC
power
supply
Section 7
Appendix
24 VDC +10% (including ripple)/15%
100 mA photo MOS outputs (PNP or NPN)
100 mA max.
2.0 V max.
RFID System
Operation Manual
151