Omron V600 Series User Manual page 126

Section 5
Communications
ABORT (XZ)
If the ID Controller does not return a response due to a problem during host communications or during
communications with a Data Carrier, the ABORT command can be executed to restore the ID
Controller to the Command Wait Status.
No response will be returned to the ABORT command.
■ 1:1 Communications
Command
Command code Terminator
X Z *
2
The ID Controller requires about 100 ms before it can receive the next command after it receives the ABORT command.
■ 1:N Communications
Command
Controller No.
@ x x
3
The ID Controller requires about 100 ms before it can receive the next command after it receives the ABORT command.
RFID System
124
Operation Manual
CR
2
Command code FCS Terminator
x x * CR
x Z
2 2 2