Omron V600 Series User Manual page 134

Section 5
Communications
PARAMETER SETTING (SP)
PARAMETER SETTINGS sets communications conditions for Data Carriers. It can be used to set all
ID Controller parameters.
■ 1:1 Communications
Command
Command code Process code
x
S P
(Upper digit) (Lower digit)
2 2
Process code upper digit
Process code lower digit
Parameter data (only when
changing parameters)
Note: The data numbers for parameter data are the numbers specified for the lower digit of the process code.
Set a value that is settable for the parameter specified in the lower digit of the process code.
Response
Command code End code
S P 0
2 2
End code
Parameter data
RFID System
132
Operation Manual
Parameter data
(only when changing parameters) Terminator
x x x x x *
0 to 4 2
Specifies the processing to perform on the parameters.
0: Change internal settings.
1: Read internal settings.
9: Initialize internal settings.
Specifies the parameter.
1: Controller number (See note.)
2: Write verification (See note.)
3: Communications mode (See note.)
5: Test switch
9: Communications mode (See note.)
A: Seven-segment output mode (See note.)
B: Lower trigger execution enable (See note.)
C: Error output time
Data No. (See
Settable values
note.)
1 Specify as a two-digit decimal number. 00 to 31 (controller number)
Default: 00
2 0: Do not verify.
1: Verify (default)
3 0: Distance Priority Mode (default)
1: Speed Priority Mode
5 0: Disabled
1: Enabled (default)
9 0: 1:1 communications (default)
1: 1:N communications
A 0: End code display (default)
1: I/O display
B 0: Disabled (default)
1: Enabled
C Specify as a four-digit decimal number. 0000 to 9999 (ms)
0000: Infinite, Default: 0500 (ms)
Parameter data Terminator
0 x x x x * CR
1 to 4 2
Indicates the results of command execution.
00: Normal end
Refer to End Codes for more information.
p.135
The parameter data when parameter setting are read.
CR
Note: Parameters 1, 2, 3, 9, A, and B are valid only
when internal settings are enabled (i.e., when
SW3 pin 1 is ON).