■ Setting the Mode Switch
SW5
OFF
ON
■ Setting the Terminating Resistance
When more than one ID Controller is connected in series to a single host device, the terminating resis-
tance must be turned ON at the nodes (ID Controller or host device) on both ends of the main cable
and turned OFF at the rest of the nodes. Operation will not be stable if the terminating resistance is not
set correctly.
The terminating resistance switch connects and disconnects the built-in terminating resistance.
SW6
OFF
ON
RUN mode
MAINTENANCE mode
Terminating resistance not connected.
Terminating resistance connected.
Preparing Communications
Description
Description
Section 3
RFID System
55
Operation Manual