Omron V600 Series User Manual page 29

RS-232C Port
■ Pin Arrangement
Signal direction
Abbre-
Pin No.
viation
Input
9 SG
2 SD
3 RD
4 RS
5 CS
■ Connecting to the Host Device
■
Connection Example to OMRON PLC
Host device
GR
SG
RD
SD
RS
CS
Shield
Note 1. Ground the shield at the host device to prevent malfunctions.
2. Pins 4 (RS) and 5 (CS) are connected inside the connector.
■
Connection Example to DOS Computer (IBM PC/AT or Compatible)
(This example uses a 9-pin D-Sub connector.)
IBM PC/AT or compatible
GR
SG
RD
SD
RS
CS
(Shield)
Note 1. The ID Controller connector on the interface cable is male
and the computer connector is female.
2. Ground the shield at the host device to prevent malfunctions.
For 1:N connections, refer to Connecting between ID Controllers (1:N Connections).
p.31
Signal name
Output
Signal ground or common
--- ---
return line
❍
--- Send data
❍
--- Receive data
❍
--- Request to send
❍
--- Can send
ID Controller
GR
SG
SD
RD Recommended Cable
RS
CS XW2Z-@@@T
ID Controller
GR
SG
SD
RD
Recommended Cable
RS
CS
XW2Z-@@@S-V
• Pin Arrangement
5
9
(The example at the left is for connecting a shielded cable to the host device.)
Model Manufacturer
OMRON
Model Manufacturer
OMRON
Section 2
Installation and Wiring
1
6
RFID System
Operation Manual
27