Omron V600 Series User Manual page 55

■ DIP Switches (SW3 and SW4)
■
SW3 Pin 1: DIP Switch/Internal Setting Selector
SW3 pin 1
OFF
ON
Note: Switches SW1, SW2, SW3 pins 2 to 10, and SW4 pins 1 to 4 are enabled only when SW3 pin 1 is OFF (DIP switches
enabled).
If the internal settings are enabled, settings made with the TR and SP commands are used.
The default settings will be used until they are changed with the TR and SP commands.
p.130, p.132
■
SW3 Pins 2 to 4: Baud Rate Setting
SW3 SW3 SW3
pin 2 pin 3 pin 4
OFF OFF OFF
OFF OFF ON
OFF ON OFF
OFF ON ON
ON OFF OFF
ON OFF ON
Other
■
SW3 Pin 5: Data Length Setting
SW3 pin 5
OFF
ON
■
SW3 Pins 6 and 7: Parity Setting
SW3 pin 6 SW3 pin 7
OFF OFF
OFF ON
ON OFF
ON ON
■
SW3 Pin 8: Stop Bit Setting
SW3 pin 8
OFF
ON
■
SW3 Pin 9: Communications Protocol Setting
SW3 pin 9
OFF
ON
■
SW3 Pin 10: Reserved.
Do not change the setting of this pin. Leave it set to OFF.
DIP switches enabled.
Internal settings enabled.
2400 bps
4800 bps
9600 bps
19200 bps
38400 bps
1200 bps
2400 bps
7 bits
8 bits
Even
None
Odd
Even
2 bits
1 bit
1:1
1:N
Preparing Communications
Description
Description
Description
Description
Description
Description
Section 3
RFID System
53
Operation Manual