S5-95F
Especially important information appears in framed boxes such as the following:
Warning
!
You will find definitions for the terms "Note", "Safety Note", "Caution",
Safety-Related Guildelines for the User at the end of the introduction.
Validity
This manual contains a detailed description of our S5-95F system with basic units 6ES5 095-8FA02,
version 1. The necessary COM 95F parameterization software is described in a separate manual.
The preceding 6ES5 095-8FA01 units are described only in release 2 of the S5-95F manual. Note
also the additional product information.
Changes Since Automation System 6ES5 095-8FA01
Please note that the functionality of basic units 6ES5 095-8FA02 is more extensive than that of the
previous units.
The principal differences between the S5-95F automation system with basic units 6ES5 095-8FA02
and the previous system are as follows:
•
The basic units can be operated from a power supply unit because high-grade voltage
monitoring is integrated in the basic unit (see section 4.1.2)
•
Interference suppression filters are no longer required for operating the basic units because the
protective devices (including those for protection from surge impulses to IEC 801-5) are
integrated in the basic unit (see Appendix A.1)
•
Additional discrepancy times selectable for interrupt processing (see section 4.2)
•
Failsafe communication using broadcast message frames (see section 13.3)
•
Simplified error acknowledgement (see section 15.4)
Training
SIEMENS offers a wide range of training courses for SIMATIC S5 users. Contact your Siemens
representative for more information.
EWA 4NEB 812 6210-02
Introduction
and "Warning" in the
xix