Table of Contents
Advertisement
Introduction
•
Module Spectrum (Appendix A)
This chapter contains the technical specifications of the S5-95F and information on the modules
that you can use to expand your controller.
•
Overviews (Appendices B through D)
In these chapters you will find not only dimension drawings and a complete list of operations but
also guidelines for handling electrostatic sensitive devices (ESD Guidelines).
•
Prototype Test Certification (Appendix E)
Certificates on prototype tests can be obtained from us on request.
Please direct inquiries to the address specified in Appendix E.
You will find correction pages at the end of the manual. Use them to indicate any corrections,
additions or suggestions for improvement you might have. Send these suggestions to us. They will
help us to improve the next edition of this manual.
Conventions
This system manual is organized in menu form to make it easier for you to find information. This
means the following:
•
Each chapter is marked with printed tabs.
•
At the front of the system manual is an overview page that lists the title of each chapter.
Following this page, you will find a table of contents.
•
At the beginning of each chapter is a table of contents for that chapter. Each chapter has three
level headings that are numbered. The fourth level heading is not numbered but appears in
boldface type.
•
Pages, figures, and tables are numbered separately for each chapter. On the back of the table
of contents for each chapter you will find a list of the figures and tables that appear in that
chapter.
This system manual employs the following specific structuring devices:
•
Specific terms have characteristic abbreviations (e.g. programmer is PG).
Appendix C contains a list of abbreviations.
•
Footnotes are marked with a raised number (e.g."
corresponding explanations in the lower margin of the page or under a figure or table if the
footnotes appears in one of these.
Lists are designed with bullets (• as in this particular listing) or with hyphens (-).
Procedures are marked with black triangles ( ) and must be performed in the sequence
presented.
•
Cross references are indicated as follows:
(see section 7.3.2)
There are no references to specific page numbers.
•
Dimensions in drawings are indicated in millimeters and inches.
xviii
"), or a raised asterisk ("
1
S5-95F
") . You will find the
*
EWA 4NEB 812 6210-02
Advertisement
Table of Contents
