Table of Contents
Advertisement
Expansion of Basic System with External 1/0s
Crimp Snap-In Terminals
Bus units using the crimp snap-in connection method have exactly the same height as the S5-95F
basic unit. You can connect stranded conductors with a cross-section of between 0.5 to 1.5 mmz to
these terminals.
How to Connect the Contact to the Terminal Block (see Figure 5-10)
Swing the terminal block up. The rear side is now visible (2).
Caution: The spring must point into the slot!
snaps into position.
5-1o
Figure 5-10. Installing a Crimp Snap-In Terminal
(l).
Press up on the terminal block until it
Advertisement
Table of Contents
