Configuring The Vs-2000; Setting Up The Vga Monitor, Mouse And Keyboard - Roland VS-2000 Owner's Manual

4—Setting Up and Basic Operations
Configuring the VS-2000

Setting Up the VGA Monitor, Mouse and Keyboard

Here's how to set up the mouse, keyboard and VGA monitor you can
use when you've installed a VS20-VGA VGA/Mouse Expansion Board
board (purchased separately):
1. Hold down SHIFT and press F4 under the display.
2. Press PAGE—if necessary—until "SYSTEM" appears above F1.
3. Press F1 (SYSTEM) beneath the display.
4. Press F3 (Param3) to display the VGA, mouse and keyboard settings.
5. Use the
If you don't have a VGA monitor, mouse or keyboard, skip over its parameters.
VGA Monitor Parameters
Parameter:
VGA OUT
REFRESH RATE
H. POSITION
V. POSITION
OPERATION
TARGET
Consult your VGA monitor's documentation for its recommended refresh rate to avoid
poor image quality and possible damage to the monitor.
The VGA parameters are described in greater detail on Page 381.
Mouse Parameters
Parameter:
PS/2 MOUSE
POINTER SPEED
MOUSE BUTTON
SWAP Sw
ASCII Keyboard Parameters
Parameter:
PS/2 KEYBOARD
KEYBOARD TYPE
66
, , and
outline darkens when it's selected—and turn the Time/Value dial to choose the
desired value.
What it sets:
Turns the VGA output on or off
Sets the rate at which the monitor
re-draws its image
Shifts the image left or right
Shifts the image up or down
Designates the internal LCD or a
connected VGA monitor as the main
operation display
What it sets:
Turns the mouse on or off
Sets how fast the mouse's cursor
moves
Sets the right- or left-handedness of
the mouse
What it sets:
Turns the keyboard on or off
Selects the nationality of the ASCII
keyboard you're using
www.Roland.com
buttons as necessary to select each setting—a setting's
Typical setting is:
On
Manufacturer's
recommended setting
0
0
see Page 381
Typical setting is:
On
3
(see Page 70)
Typical setting is:
On
101/104 (in USA);
106/109 (Japan)
Roland VS-2000 Owner's Manual
+