Replacing A Disk (Vcx Connect) - 3Com VCX V7000 Installation Manual

Replacing a Disk
(VCX Connect)
Instructions
(Single Site,
Two Servers)
Use the procedures in this section to replace a failed disk at a VCX
Connect site that has either:
Two servers (primary and secondary)
■
A single server (standalone)
■
Use the appropriate instructions from this section to replace the disk on
the Primary or Secondary VCX Connect server and bring the server back
into operation.
If this server is configured for RAID operation, see
earlier in this appendix.
1 Replace the failed disk and start the server.
a Remove power from the down server.
b Remove the failed disk.
c Install the replacement disk.
d Reapply power to the server.
e If the server is a VCX Connect 200 server, press the start button on the
front panel. If the server is a VCX Connect 100 server, applying power
to the server automatically starts the server.
2 After the server has started and the login prompt appears, log in as root
and configure networking parameters on the down server by entering
this command:
vcx-config-network --wizard
Follow the instructions in "VCX Connect Installation and Configuration
Guide" (a separate document for use with VCX Connect systems only).
3 Reboot the down server using this command:
reboot
4 After the reboot process has been completed, configure VCX services on
the down server using this command:
vcx-setup
The script detects that you have already configured the networking
parameters for the server and prompts you to configure VCX Services.
Follow the instructions in "VCX Connect Installation and Configuration
Guide" (a separate document for use with VCX Connect systems only).

Replacing a Disk (VCX Connect)

RAID Disk
423
Failure,