Instructions For Connection - Panasonic SL-VGU1-EC User Manual

Cable Connection

Instructions for Connection

Process and tighten the wires as follows:
Wire processing dimension
Lead wire
Loosens
● Take care that wrong wiring will damage the product.
● Do not short-circuit '0V' and 'G' on the S-LINK V terminal block connector side.
● A large current may flow through the external power supply input, depending on the load. Use wires having
sufficient current capacity. Further, when supplying power to the load from SL-VGU1-EC, make sure not to
exceed the allowable through current.
● Tighten the screws of the flange also, so that the terminal block does not come out. The tightening torque
should be 0.5N·m, or less, on the S-LINK V terminal block connector side and 0.2N·m, or less.
● Do not apply solder, etc., on the tips of the wires to be connected to the terminal block. This can cause loos-
ening of the screws, resulting in wire disconnection.
25
<Dimension A>
S-LINK V terminal block connector side: 7mm
Tightens
<Tightening torque>
S-LINK V terminal block connector side: 0.5N·m or less
Recommended tool: Small-sized flathead screwdriver
S-LINK V terminal block connector side:
Width = 3.8mm or less, thickness = 0.7mm or less