Panasonic SL-VGU1-EC User Manual page 41

Mode setting Operation
Follow the same operation
procedure as I/O setting 0.
The I/O setting will be
switched in the order of 1
to 3.
k ey.
Press
Press ENTER key.
k e y o r
Press
Press ENTER key.
k ey.
Press
Press ENTER key.
k e y o r
Press
Press ENTER key.
Follow the same operation
procedure as error 1.
Switching in the order of
errors 2, 3, 4 and 5
P res s k e y.
Press ENTER key.
(for 3 seconds)
P res s k e y.
Press ENTER key.
Press continuously until it
blinks (for 3 seconds)
Description / Function
Same as I/O setting 0
I/O setting 1
Input
Output
Addresses 224 to 255
Addresses 192 to 223
Addresses 160 to 191
Addresses 128 to 159
I/O setting 1
I/O setting 3
Input
Output
Addresses 480 to 511
Addresses 448 to 479
Addresses 416 to 447
Addresses 384 to 415
I/O setting 3
Displays the output hold / clear.
Blinks the displayed output hold / clear.
k ey.
Selects either the output hold or the output clear.
Determines the output hold or the output clear.
(For a detailed description, refer to page 41.)
Displays the error 1 output operation.
Blinks the displayed error 1 output operation.
Selects the external output type for the detected error
from the following two types:
: Outputs the error signal from error output 1 of the
k ey.
controller.
: Will not output any error signal.
Determines the error 1 output operation.
Same as error 1
Displays the code of the default setting.
Displays the indicator check pattern, and sets the default
values.
Sequentially displays all the setting items of the CONFIG
mode, and sets these items to the initial values (default
values).
Clears the addresses of all the units specified in the
system setting.
Displays the code of the system setting.
Enters the system setting (blinks).
Blinks the number of connected nodes (I/O units).
I/O setting 2
Input
Output
Addresses 352 to 383
Addresses 320 to 351
Addresses 288 to 319
Addresses 256 to 287
I/O setting 2
Same as I/O setting 0
Example
If the output hold
is selected:
If the output clear
is selected:
Example
Example
Error output 1
No error output
Example
Same as error 1
End
Example
If 4 I/O units are
connected:
End
Starting
Indication
40