Panasonic SL-VGU1-EC User Manual page 22

Functional Description
No. Designation
3 ENTER key
4 SELECT keys
5 Mode selection switch
Transmission
6
indicator (Green)
7 Error indicator (Red)
S-LINK V terminal
8
block connector
EtherCAT connector
9
(OUT side)
EtherCAT connector
10
(IN side)
Station address setting
11
switches
L/A IN
(Green)
L/A OUT
(Green)
EtherCAT
12
indicator
RUN
(Green)
ECAT ERR
(Red)
21
● When the ENTER key is pressed, the setting value of each setting is entered.
● When system set is displayed, if ENTER key is pressed for 3 sec., or more, system set is performed.
● They are used to change the displayed item or setting item, and to change the numerical value of each
setting.
● It is used to change to RUN / CHECK / CONFIG modes.
● It blinks during transmission. The frequency of blinking differs depending on the transmission mode.
● It shows the error condition.
• Lights up: Error occurrence
• Blinks: Cause rectified after error occurrence (error record).
● +24V, 0V and F.G. are supplied from the external power supply, and +24V, 0V, D and G are supplied to
I/O units. Further, the error output is connected to the external device.
● It is the RJ45 modular jack for connection of EtherCAT transmission signal.
● These switches are for setting the station address.
• "x256" sets the 256 position
• "x16" sets the 16 position
• "x1" sets the 1 position
● Link: Normal and Activity: Normal ··· Blinks
● Link: Normal and Activity: Error ··· Lights up
● Link: Error ··· Turns OFF
● Lights up: OPstate
● Blinks: SAFE-OP / PRE-OP state
● Turns OFF: INIT state
● Lights up or Blinks when EtherCAT error occurs.
Description