HP 3562A Service Manual page 420

MODEL 3562A
B.
Fault log
The fault l o g lists the A2 System CPU run-time errors or discrepancies. It also gives the
revision code of the software that is in the instrument. Only assemblies that use the syst
bus generate fault log error messages, however, a failure on any assembly may cause a
fault log entry. Use the fault log as a supplement to the fault isolation procedure. To
read the test log press the keys as follows:
SPC l
. . .
FCTN .
Fault log messages accumulate in the fault log until the log i s cleared. Use table 7-18
to interpret fault log messages.
Using beeper commands other than those spec ified in this manual
may result in a 'software fault' entry in the fault log.
7-56
SERVICE
. .
TEST . . . . , . TEST
RESULT . . . . . . FAULT
NOTE
FAULT ISOLATION
LOG
e
m