Task
Display OSPFv3 next hop
information.
Display OSPFv3 neighbor
information.
Display OSPFv3 request list
information.
Display OSPFv3 retransmission list
information.
Display OSPFv3 routing information.
Display OSPFv3 topology
information.
Display OSPFv3 statistics.
Display OSPFv3 virtual link
information.
Clear OSPFv3 log information.
Restart an OSPFv3 process.
Restart OSPFv3 route redistribution.
Clear OSPFv3 statistics.
OSPFv3 configuration examples
OSPFv3 stub area configuration example
Network requirements
As shown in
•
Enable OSPFv3 on all switches.
•
Split the AS into three areas.
•
Configure Switch B and Switch C as ABRs to forward routing information between areas.
•
Configure Area 2 as a stub area to reduce LSAs in the area without affecting route reachability.
Figure 101 Network diagram
Switch B
OSPFv3
Vlan-int200
Area 1
2001:1::2/64
Switch A
Figure
101:
OSPFv3
Area 0
Vlan-int100
2001::1/64
Vlan-int100
2001::2/64
Vlan-int200
2001:1::1/64
Vlan-int300
2001:3::1/64
Command
display ospfv3 [ process-id ] nexthop
display ospfv3 [ process-id ] [ area area-id ] peer [ [ interface-type
interface-number ] [ verbose ] | peer-router-id | statistics ]
display ospfv3 [ process-id ] [ area area-id ] request-queue
[ interface-type interface-number ] [ neighbor-id ]
display ospfv3 [ process-id ] [ area area-id ] retrans-queue
[ interface-type interface-number ] [ neighbor-id ]
display ospfv3 [ process-id ] routing [ ipv6-address prefix-length ]
display ospfv3 [ process-id ] [ area area-id ] spf-tree [ verbose ]
display ospfv3 [ process-id ] statistics [ error ]
display ospfv3 [ process-id ] vlink
reset ospfv3 [ process-id ] event-log [ lsa-flush | peer | spf ]
reset ospfv3 [ process-id ] process [ graceful-restart ]
reset ospfv3 [ process-id ] redistribution
reset ospfv3 [ process-id ] statistics
Switch C
Vlan-int400
2001:2::1/64
OSPFv3
Vlan-int400
Area 2
2001:2::2/64
Switch D
449