Ospfv3 Route Redistribution Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
The output shows that Switch A becomes the DR.

OSPFv3 route redistribution configuration example

Network requirements
As shown in
•
Switch A, Switch B, and Switch C are in Area 2.
•
OSPFv3 process 1 and OSPFv3 process 2 run on Switch B. Switch B communicates with
Switch A and Switch C through OSPFv3 process 1 and OSPFv3 process 2.
•
Configure OSPFv3 process 2 to redistribute direct routes and the routes from OSPFv3 process
1 on Switch B, and set the default metric for redistributed routes to 3. Switch C can then learn
the routes destined for 1::0/64 and 2::0/64, and Switch A cannot learn the routes destined for
3::0/64 or 4::0/64.
Figure 104 Network diagram
Vlan-int200
2::1/64
Switch A
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# Enable OSPFv3 process 1 on Switch A.
<SwitchA> system-view
[SwitchA] ospfv3 1
[SwitchA-ospfv3-1] router-id 1.1.1.1
Pri State
0 Full/DROther
2 Full/BDR
1 Full/DROther
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/BDR
Figure 104:
Vlan-int100
1::1/64
Process 1
Area 2
Vlan-int100
1::2/64
Dead-Time InstID Interface
00:00:36
00:00:35
00:00:33
Dead-Time InstID Interface
00:00:30
00:00:37
00:00:31
Vlan-int300
3::2/64
Process 2
Area 2
Vlan-int300
3::1/64
Switch B
459
0 Vlan200
0 Vlan100
0 Vlan200
0 Vlan100
0 Vlan200
0 Vlan100
Vlan-int400
4::1/64
Switch C