HP HPE FlexNetwork 7500 series Configuration Manual page 221

Tasks at a glance
(Optional.) Tuning and optimizing BGP
•
Configuring the keepalive interval and hold time
•
Setting the session retry timer
•
Configuring the interval for sending updates for the same route
•
Enabling BGP to establish an EBGP session over multiple hops
•
Enabling immediate re-establishment of direct EBGP connections upon link
failure
•
Enabling BGP ORF capabilities
•
Enabling 4-byte AS number suppression
•
Enabling MD5 authentication for BGP peers
•
Enabling keychain authentication for BGP peers
•
Configuring BGP load balancing
•
Disabling BGP to establish a session to a peer or peer group
•
Configuring GTSM for BGP
•
Configuring BGP soft-reset
•
Protecting an EBGP peer when memory usage reaches level 2 threshold
•
Configuring an update delay for local MPLS labels
•
Flushing the suboptimal BGP route to the RIB
•
Setting a DSCP value for outgoing BGP packets
•
Disabling route recursion policy control for routes received from a peer or
peer group
•
Enabling per-prefix label allocation
•
Disabling optimal route selection for labeled routes without tunnel information
(Optional.) Configuring a large-scale BGP
•
Configuring BGP community
•
Configuring BGP route reflection
•
Configuring a BGP confederation
(Optional.) Configuring BGP GR
(Optional.) Configuring BGP NSR
(Optional.) Enabling SNMP notifications for BGP
(Optional.) Enabling logging for session state changes
(Optional.) Enabling logging for BGP route flapping
(Optional.) Configuring BFD for BGP
(Optional.) Configuring BGP FRR
(Optional.) Configuring 6PE
(Optional.) Configuring BGP LS
(Optional.) Configuring BMP
To configure BGP, perform the following tasks (IPv6 unicast/IPv6 multicast):
networks:
network:
209
Remarks
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
BGP does not support
FRR for IPv4 multicast
routes.
N/A
N/A
N/A