Bfd For Ospfv3 Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

[SwitchS] interface vlan-interface 100
[SwitchS-Vlan-interface100] ospfv3 1 area 1
[SwitchS-Vlan-interface100] quit
[SwitchS] interface vlan-interface 200
[SwitchS-Vlan-interface200] ospfv3 1 area 1
[SwitchS-Vlan-interface200] quit
Verifying the configuration
# Verify the following:
•
When an active/standby switchover occurs on Switch S, the neighbor relationships and routing
information on Switch A and Switch B have not changed. (Details not shown.)
•
The traffic from Switch A to Switch B has not been impacted. (Details not shown.)

BFD for OSPFv3 configuration example

Network requirements
As shown in
•
Configure OSPFv3 on Switch A, Switch B and Switch C and configure BFD over the link Switch
A<—>L2 Switch<—>Switch B.
•
After the link Switch A<—>L2 Switch<—>Switch B fails, BFD can quickly detect the failure and
notify OSPFv3 of the failure. Then Switch A and Switch B communicate through Switch C.
Figure 108 Network diagram
2001:1::/64
Table 26 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown.)
2. Configure basic OSPFv3:
Figure 108:
Switch A
Vlan-int10
Vlan-int11
L2 Switch
Area 0
Vlan-int11
Switch C
BFD
Switch B
Vlan-int10
Vlan-int13
Vlan-int13
Interface
Vlan-int10
Vlan-int11
Vlan-int10
Vlan-int13
Vlan-int11
Vlan-int13
468
2001:4::/64
IPv6 address
2001::1/64
2001:2::1/64
2001::2/64
2001:3::2/64
2001:2::2/64
2001:3::1/64