Configuring Ripng Route Redistribution; Tuning And Optimizing The Ripng Network; Setting Ripng Timers - HP HPE FlexNetwork 7500 series Configuration Manual

Step
1. Enter system view.
2. Enter RIPng view.
3. Set a preference for RIPng.

Configuring RIPng route redistribution

Step
1. Enter system view.
2. Enter RIPng view.
3. Redistribute routes from
other routing protocols.
4. (Optional.) Set a default
routing metric for
redistributed routes.

Tuning and optimizing the RIPng network

This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments.
Before you tune and optimize the RIPng network, complete the following tasks:
•
Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring
nodes.
•
Configure basic RIPng.

Setting RIPng timers

You can adjust RIPng timers to optimize the performance of the RIPng network.
When you adjust RIPng timers, consider the network performance, and perform unified
configurations on routers running RIPng to avoid unnecessary network traffic or route oscillation.
To set RIPng timers:
Step
1. Enter system view.
2. Enter RIPng view.
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
preference { preference |
route-policy route-policy-name }
*
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
import-route protocol
[ as-number | process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost-value | route-policy
route-policy-name ] *
default cost cost-value
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
410
Remarks
N/A
N/A
By default, the preference of
RIPng is 100.
Remarks
N/A
N/A
By default, RIPng does not
redistribute routes from other
routing protocols.
The default metric of redistributed
routes is 0.
Remarks
N/A
N/A