Tasks at a glance
(Optional.)
•
Configuring the keepalive interval and hold time
•
Setting the session retry timer
•
Configuring the interval for sending updates for the same route
•
Enabling BGP to establish an EBGP session over multiple hops
•
Enabling immediate re-establishment of direct EBGP connections upon link
failure
•
Enabling BGP ORF capabilities
•
Enabling 4-byte AS number suppression
•
Enabling MD5 authentication for BGP peers
•
Enabling keychain authentication for BGP peers
•
Configuring BGP load balancing
•
Disabling BGP to establish a session to a peer or peer group
•
Configuring GTSM for BGP
•
Configuring BGP soft-reset
•
Protecting an EBGP peer when memory usage reaches level 2 threshold
•
Configuring an update delay for local MPLS labels
•
Flushing the suboptimal BGP route to the RIB
•
Setting a DSCP value for outgoing BGP packets
•
Disabling route recursion policy control for routes received from a peer or
peer group
•
Enabling per-prefix label allocation
•
Disabling optimal route selection for labeled routes without tunnel information
(Optional.)
•
Configuring BGP community
•
Configuring BGP route reflection
•
Configuring a BGP confederation
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuring basic BGP
This section describes the basic settings required for a BGP network to run.
Tuning and optimizing BGP
Configuring a large-scale BGP
Configuring BGP GR
Configuring BGP NSR
Enabling SNMP notifications for BGP
Enabling logging for session state changes
Enabling logging for BGP route flapping
Configuring BFD for BGP
Configuring BGP FRR
Configuring 6PE
Configuring BGP LS
networks:
network:
211
Remarks
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
BGP does not support
FRR for IPv6 multicast
routes.
IPv6 multicast does not
support 6PE.
N/A