Aaa Configuration Examples; Aaa For Telnet Users By An Hwtacacs Server - HP 3600 v2 Series Configuration Manual

Task
Display information about user
connections.

AAA configuration examples

Unless otherwise noted, devices in the configuration examples are operating in non-FIPS mode.

AAA for Telnet users by an HWTACACS server

Network requirements
As shown in
authorization, and accounting services for Telnet users.
Set the shared keys for secure communication with the HWTACACS server to expert. Configure the
switch to remove the domain name from a username before sending the username to the HWTACACS
server.
Figure 11 Network diagram
Telnet user
Configuration procedure
1. Configure the switch:
# Assign IP addresses to the interfaces. (Details not shown.)
# Enable the Telnet server on the switch.
<Switch> system-view
[Switch] telnet server enable
# Configure the switch to use AAA for Telnet users.
[Switch] user-interface vty 0 4
[Switch-ui-vty0-4] authentication-mode scheme
[Switch-ui-vty0-4] quit
Command
display connection [ access-type { dot1x |
mac-authentication | portal } | domain
isp-name | interface interface-type
interface-number | ip ip-address | mac
mac-address | ucibindex ucib-index |
user-name user-name | vlan vlan-id ] [ slot
slot-number ] [ | { begin | exclude | include }
regular-expression ]
Figure 1 1, configure the switch to use the HWTACACS server to provide authentication,
HWTACACS server
10.1.1.1/24
Switch
Internet
51
Remarks
Available in any view