HP HPE FlexNetwork 7500 series Configuration Manual page 120

Figure 25 Network diagram
Switch A
Vlan-int200
Area 1
10.2.1.2/24
Switch C
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Enable OSPF (see
3. Configure OSPF to redistribute routes:
# On Switch C, configure a static route destined for network 3.1.2.0/24.
<SwitchC> system-view
[SwitchC] ip route-static 3.1.2.1 24 10.4.1.2
# On Switch C, configure OSPF to redistribute static routes.
[SwitchC] ospf 1
[SwitchC-ospf-1] import-route static
Verifying the configuration
# Display the ABR/ASBR information on Switch D.
<SwitchD> display ospf abr-asbr
OSPF Process 1 with Router ID 10.5.1.1
Type
Intra
Inter
# Display the OSPF routing table on Switch D.
<SwitchD> display ospf routing
OSPF Process 1 with Router ID 10.5.1.1
Routing for network
Destination
10.2.1.0/24
10.3.1.0/24
Area 0
Vlan-int100
10.1.1.1/24
Vlan-int100
10.1.1.2/24
Vlan-int200
10.2.1.1/24
Area 2
Vlan-int300
Vlan-int500
10.4.1.1/24
10.5.1.1/24
"Basic OSPF configuration
Routing Table to ABR and ASBR
Topology base (MTID 0)
Destination Area
10.3.1.1 0.0.0.2
10.4.1.1 0.0.0.2
Routing Table
Topology base (MTID 0)
Cost Type
22 Inter
10 Transit 10.3.1.2
Switch B
Vlan-int200
10.3.1.1/24
Vlan-int200
10.3.1.2/24
Switch D
example").
Cost Nexthop
10 10.3.1.1
22 10.3.1.1
NextHop
10.3.1.1
108
RtType
ABR
ASBR
AdvRouter Area
10.3.1.1 0.0.0.2
10.3.1.1 0.0.0.2