Table of Contents
Advertisement
Step
2.
Enter RIPng view.
3.
Enable the zero field check
on incoming RIPng packets.
Setting the maximum number of ECMP routes
Step
1.
Enter system view.
2.
Enter RIPng view.
3.
Set the maximum number
of ECMP routes.
Configuring the RIPng packet sending rate
Perform this task to specify the interval for sending RIPng packets and the maximum number of
RIPng packets that can be sent at each interval. This feature can avoid excessive RIPng packets
from affecting system performance and consuming too much bandwidth.
To configure the RIPng packet sending rate:
Step
1.
Enter system view.
2.
Enter RIPng view.
3.
Set the interval for sending
RIPng packets and the
maximum number of RIPng
packets that can be sent at
each interval.
4.
Return to system view.
5.
Enter interface view.
6.
Set the interval for sending
RIPng packets and the
maximum number of RIPng
packets that can be sent at
each interval.
Command
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
checkzero
Command
system-view
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
maximum load-balancing number
Command
system-view
ripng [ process-id ]
[ vpn-instance
vpn-instance-name ]
output-delay time count count
quit
interface interface-type
interface-number
ripng output-delay time count
count
412
Remarks
N/A
By default, zero field check is
enabled for incoming RIPng
packets.
Remarks
N/A
N/A
By default, the maximum number
of ECMP routes equals the
maximum number of ECMP
routes supported by the system.
Remarks
N/A
N/A
By default, a RIPng process
sends a maximum of three RIPng
packets every 20 milliseconds.
N/A
N/A
By default, an interface uses the
RIPng packet sending rate
configured for the RIPng process
that the interface runs.
Advertisement
Table of Contents
Troubleshooting
