Setting The Lsu Transmit Rate; Configuring Stub Routers - HP HPE FlexNetwork 7500 series Configuration Manual

Step
2. Bind MIB to an OSPFv3
process.
3. Enable SNMP notifications
for OSPFv3.
4. Enter OSPFv3 view.
5. Configure an SNMP
context for the OSPFv3
process.
6. (Optional.) Set the SNMP
notification output interval
and the maximum number
of SNMP notifications that
can be output at each
interval.

Setting the LSU transmit rate

Sending large numbers of LSU packets affects router performance and consumes a large amount of
network bandwidth. You can configure the router to send LSU packets at an interval and to limit the
maximum number of LSU packets sent out of an OSPFv3 interface at each interval.
To set the LSU transmit rate:
Step
1. Enter system view.
2. Enter OSPFv3
view.
3. Set the LSU
transmit rate.

Configuring stub routers

A stub router is used for traffic control. It reports its status as a stub router to neighboring OSPFv3
routers. The neighboring routers can have a route to the stub router, but they do not use the stub
router to forward data.
Use either of the following methods to configure a router as a stub router:
•
Clear the R-bit of the Option field in Type-1 LSAs. When the R-bit is clear, the OSPFv3 router
can participate in OSPFv3 topology distribution without forwarding traffic.
Command
ospfv3 mib-binding process-id
snmp-agent trap enable ospfv3
[ grrestarter-status-change |
grhelper-status-change |
if-state-change | if-cfg-error |
if-bad-pkt | neighbor-state-change |
nssatranslator-status-change |
virtif-bad-pkt | virtif-cfg-error |
virtif-state-change |
virtgrhelper-status-change |
virtneighbor-state-change ]*
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
snmp context-name context-name
snmp trap rate-limit interval
trap-interval count trap-number
Command
system-view
ospfv3 [ process-id | vpn-instance
vpn-instance-name ] *
transmit-pacing interval interval count count
441
Remarks
By default, MIB is bound to the
process with the smallest
process ID.
By default, SNMP notifications
for OSPFv3 are enabled.
N/A
By default, no SNMP context is
configured for the OSPFv3
process.
By default, OSPFv3 outputs a
maximum of seven SNMP
notifications within 10
seconds.
Remarks
N/A
N/A
By default, an OSPFv3
interface sends a maximum of
three LSU packets every 20
milliseconds.