Table of Contents
Advertisement
Device
Switch C
Switch C
Switch D
Switch D
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure static routes and BFD:
# Configure static routes on Switch A and enable BFD control mode for the static route that
traverses Switch D.
<SwitchA> system-view
[SwitchA] bfd multi-hop min-transmit-interval 500
[SwitchA] bfd multi-hop min-receive-interval 500
[SwitchA] bfd multi-hop detect-multiplier 9
[SwitchA] ip route-static 120.1.1.0 24 2.2.2.9 bfd control-packet bfd-source 1.1.1.9
[SwitchA] ip route-static 120.1.1.0 24 vlan-interface 11 10.1.1.100 preference 65
[SwitchA] quit
# Configure static routes on Switch B and enable BFD control mode for the static route that
traverses Switch D.
<SwitchB> system-view
[SwitchB] bfd multi-hop min-transmit-interval 500
[SwitchB] bfd multi-hop min-receive-interval 500
[SwitchB] bfd multi-hop detect-multiplier 9
[SwitchB] ip route-static 121.1.1.0 24 1.1.1.9 bfd control-packet bfd-source 2.2.2.9
[SwitchB] ip route-static 121.1.1.0 24 vlan-interface 13 13.1.1.2 preference 65
[SwitchB] quit
# Configure static routes on Switch C.
<SwitchC> system-view
[SwitchC] ip route-static 120.1.1.0 24 13.1.1.1
[SwitchC] ip route-static 121.1.1.0 24 10.1.1.102
# Configure static routes on Switch D.
<SwitchD> system-view
[SwitchD] ip route-static 120.1.1.0 24 11.1.1.1
[SwitchD] ip route-static 121.1.1.0 24 12.1.1.1
Verifying the configuration
# Display BFD sessions on Switch A.
<SwitchA> display bfd session
Total Session Num: 1
IPv4 Session Working Under Ctrl Mode:
LD/RD
4/7
The output shows that the BFD session has been created.
Interface
VLAN-interface 11
VLAN-interface 13
VLAN-interface 10
VLAN-interface 12
Up Session Num: 1
SourceAddr
DestAddr
1.1.1.9
2.2.2.9
IP address
10.1.1.100/24
13.1.1.2/24
12.1.1.2/24
11.1.1.2/24
Init Mode: Active
State
Up
20
Holdtime
Interface
2000ms
N/A
Advertisement
Table of Contents
Troubleshooting
