Ospfv3 Configuration Examples; Configuring Ospfv3 Areas - HP 3600 v2 series Configuration Manual

To do...
Display OSPFv3 link state request
list information
Display OSPFv3 link state
retransmission list information
Display OSPFv3 statistics
Display the GR status of the
specified OSPFv3 process

OSPFv3 configuration examples

Configuring OSPFv3 areas

Network requirements
In Figure 107, all switches run OSPFv3. The AS is split into three areas, in which, Switch B and Switch C
act as ABRs to forward routing information between areas.
Configure Area 2 as a stub area in order to reduce LSAs in the area without affecting route reachability.
Figure 107 Network diagram
Configuration procedure
Configure IPv6 addresses for interfaces. (Details not shown)
1.
Configure OSPFv3 basic functions.
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ospfv3
Use the command...
display ospfv3 [ process-id ] request-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ] [ | { begin | exclude | include }
regular-expression ]
display ospfv3 [ process-id ] retrans-list [ { external |
inter-prefix | inter-router | intra-prefix | link | network
| router | grace } [ link-state-id ] [ originate-router
ip-address ] | statistics ] [ | { begin | exclude | include }
regular-expression ]
display ospfv3 statistic [ | { begin | exclude | include }
regular-expression ]
display ospfv3 [ process-id ] graceful-restart status [ |
{ begin | exclude | include } regular-expression ]
296
Remarks