Setting The Lsa Generation Interval; Disabling Interfaces From Receiving And Sending Ospf Packets - HP HPE FlexNetwork 7500 series Configuration Manual

Step
3. Set the LSA arrival interval.

Setting the LSA generation interval

Adjust the LSA generation interval to protect network resources and routers from being overwhelmed
by LSAs at the time of frequent network changes.
For a stable network, the minimum interval is used. If network changes become frequent, the LSA
generation interval is incremented by the incremental interval × 2
maximum interval is reached. The value n is the number of generation times.
To set the LSA generation interval:
Step
1. Enter system view.
2. Enter OSPF view.
3. Set the LSA
generation interval.
Disabling interfaces from receiving and sending OSPF
packets
To enhance OSPF adaptability and reduce resource consumption, you can set an OSPF interface to
"silent." A silent OSPF interface blocks OSPF packets and cannot establish any OSPF neighbor
relationship. However, other interfaces on the router can still advertise direct routes of the interface in
Router LSAs.
To disable interfaces from receiving and sending routing information:
Step
1. Enter system view.
2. Enter OSPF view.
Command
lsa-arrival-interval interval
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
lsa-generation-interval
maximum-interval [ minimum-interval
[ incremental-interval ] ]
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
87
Remarks
The default setting is 1000
milliseconds.
Make sure this interval is smaller
than or equal to the interval set with
the lsa-generation-interval
command.
n-2
for each generation until the
Remarks
N/A
N/A
By default:
•
The maximum interval is 5
seconds.
•
The minimum interval is 50
milliseconds.
•
The incremental interval is 200
milliseconds.
Remarks
N/A
N/A