Ripng Route Redistribution Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

Peer FE80::2:100 on Vlan-interface100
Destination 4::/64,
via FE80::1:100, cost 2, tag 0, AOF, 2 secs

RIPng route redistribution configuration example

Network requirements
As shown in
through RIPng 200.
Configure route redistribution on Switch B, so the two RIPng processes can redistribute routes from
each other.
Figure 96 Network diagram
Vlan-int200
2::1/64
Switch A
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Enable RIPng 100 on Switch A.
<SwitchA> system-view
[SwitchA] ripng 100
[SwitchA-ripng-100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 100 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ripng 100 enable
[SwitchA-Vlan-interface200] quit
# Enable RIPng 100 and RIPng 200 on Switch B.
<SwitchB> system-view
[SwitchB] ripng 100
[SwitchB-ripng-100] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ripng 100 enable
[SwitchB-Vlan-interface100] quit
[SwitchB] ripng 200
[SwitchB-ripng-200] quit
[SwitchB] interface vlan-interface 300
[SwitchB-Vlan-interface300] ripng 200 enable
[SwitchB-Vlan-interface300] quit
# Enable RIPng 200 on Switch C.
<SwitchC> system-view
[SwitchC] ripng 200
Figure 96, Switch B communicates with Switch A through RIPng 100 and with Switch C
RIPng 100
Vlan-int100
1::1/64
Vlan-int100
1::2/64
RIPng 200
Vlan-int300
3::1/64
Vlan-int300
3::2/64
Switch B
419
Vlan-int400
4::1/64
Switch C