Ripng Nsr Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

Figure 97 Network diagram
Vlan-int100
2000::2/24
GR helper
Router ID: 2.2.2.2
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure RIPng on the switches to ensure the following: (Details not shown.)
Switch A, Switch B, and Switch C can communicate with each other at Layer 3.

Dynamic route update can be implemented among them with RIPng.

3. Enable RIPng GR on Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] graceful-restart
Verifying the configuration
# Restart RIPng process 1 on Switch A.
[SwitchA-ripng-1] return
<SwitchA> reset ripng 1 process
Reset RIPng process? [Y/N]:y
# Display GR information on Switch A.
<SwitchA> display ripng 1 graceful-restart
RIPng process: 1
Graceful Restart capability
Current GR state
Graceful Restart period
Graceful Restart remaining time: 0

RIPng NSR configuration example

Network requirements
As shown in
RIPng.
Enable RIPng NSR on Switch S to ensure correct routing when an active/standby switchover occurs
on Switch S.
Router ID: 1.1.1.1
GR restarter
Switch A
Vlan-int100
2000::1/24
Vlan-int100
2000::3/24
Switch B Switch C
Router ID: 3.3.3.3
Figure 98, Switch S, Switch A, and Switch B learn IPv6 routing information through
GR helper
: Enabled
: Normal
: 60 seconds
seconds
422