HP HPE FlexNetwork 7500 series Configuration Manual page 138

[SwitchS-ospf-100] quit
Verifying the configuration
# Perform an active/standby switchover on Switch S.
[SwitchS] placement reoptimize
Predicted changes to the placement
Program
---------------------------------------------------------------------
lb
lsm
slsp
rib6
routepolicy
rib
staticroute6
staticroute
eviisis
ospf
Continue? [y/n]:y
Re-optimization of the placement start. You will be notified on completion
Re-optimization of the placement complete. Use 'display placement' to view the new
placement
# During the switchover period, display OSPF neighbors on Switch A to verify the neighbor
relationship between Switch A and Switch S.
<SwitchA> display ospf peer
OSPF Process 1 with Router ID 2.2.2.1
Area: 0.0.0.0
Router ID
3.3.3.1
# Display OSPF routes on Switch A to verify if Switch A has a route to the loopback interface on
Switch B.
<SwitchA> display ospf routing
OSPF Process 1 with Router ID 2.2.2.1
Routing for network
Destination
44.44.44.44/32
14.14.14.0/24
22.22.22.22/32
12.12.12.0/24
Total nets: 4
Neighbor Brief Information
Address Pri Dead-Time
12.12.12.2 1
Routing Table
Topology base (MTID 0)
Cost Type
2 Stub
2 Transit 12.12.12.2
0 Stub
1 Transit 12.12.12.1
Current location
0/0
0/0
0/0
0/0
0/0
0/0
0/0
0/0
0/0
0/0
State
37 Full/BDR
NextHop
12.12.12.2
22.22.22.22
126
New location
0/0
0/0
0/0
0/0
0/0
0/0
0/0
0/0
0/0
1/0
Interface
Vlan100
AdvRouter Area
4.4.4.1 0.0.0.0
4.4.4.1 0.0.0.0
2.2.2.1 0.0.0.0
2.2.2.1 0.0.0.0