Draytek Vigor2860 User Manual page 913

S y n t a x
S y n t a x
wl scan [start]
wl scan set [wlist/blist/stime][MAC]
wl scan del [wlist/blist] [MAC]
wl scan filter [ssid/channel/mac]
wl scan show [0/1/2/3]
S y n t a x
S y n t a x
Parameter
start
set [wlist/blist/stime]
[MAC]
del
filter
show [0/1/2/3]
E x a m p l
E x a m p
>
wl scan set wlist 001122aabbcc
>
wl scan start
>
wl scan show 3
>
T e l n e t C o m m
T e l n e t C o m m
This command is used to configure connection time and reconnection time for each SSID that
wireless client used for accessing into Internet.
S S y y n n t t a a x x
wl stamgt [enable/disable] [ssid_num].
wl stamgt [show] [ssid_num].
wl stamgt set [ssid_num] [c] [r]
wl stamgt reset [ssid_num].
S S y y n n t t a a x x
Vigor2860 Series User's Guide
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to start AP scanning.
Set white list/block list/scan time.
wlist – It means to set white list for passing. MAC address must be
added in the end.
e.g., wl scan set wlist 001122aabbcc
blist – It means to set black list for blocking. MAC address must be
added in the end.
stime – It means to set scanning time. Time value (2~5 second) must
be added in the end.
e.g., wl scan set time 5
Remove white list/block list.
e.g., wl scan del wlist 001122aabbcc
Set which filter you want.
ssid – scanning the AP based on SSID setting.
channel - scanning the AP based on channel setting.
mac - scanning the AP based on MAC address setting..
It is used to show AP list.
0 - display white list
1 - display block list,
2 - display gray/unknown list,
3 - display all list
e
l e
a n d : w l s t a m g t
a n d : w l s t a m g t
D D e e s s c c r r i i p p t t i i o o n n
899