Draytek Vigor2860 User Manual page 829

WAN1 Outbound TCP ACK Prioritizel set to enable
QoS WAN1 set complete; restart QoS
>
T e l n e t C o m m
T e l n e t C o m m
This command allows user to set QoS class.
S y n t a x
S y n t a x
qos class -c [no] –[a|e|d] [no][-<command> <parameter> | ... ]
S y n t a x
S y n t a x
Parameter
[<command>
<parameter>|...]
-h
-c <no>
-n <name>
-a
-e <no>
-d <no>
-m <mode>
-l <addr>
-r <addr>
-p <DSCP id>
-s <Service type>
Vigor2860 Series User's Guide
a n d : q o s c l a s s
a n d : q o s c l a s s
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Type it to display the usage of this command.
Specify the inde number for the class.
Available value for <no> contains 1, 2 and 3. The default setting is
class 1.
It means to type a name for the class.
It means to add rule for specified class.
It means to edit specified rule.
<no>: type the index number for the rule.
It means to delete specified rule.
<no>: type the index number for the rule.
It means to enable or disable the specified rule.
0: disable,
1: enable
Set the local address.
Addr1 – It means Single address. Please specify the IP address
directly, for example, "-l 172.16.3.9".
addr1:addr2 – It means Range address. Please specify the IP
addresses, for example, "-l 172.16.3.9: 172.16.3.50."
addr1:subnet – It means the subnet address with start IP address.
Please type the subnet and the IP address, for example, "-l
172.16.3.9:255.255.0.0".0
any – It means Any address. Simple type "-l" to specify any address
for this command.
Set the remote address.
addr1 – It means Single address. Please specify the IP address
directly, for example, "-l 172.16.3.9".
addr1:addr2 – It means Range address. Please specify the IP
addresses, for example, "-l 172.16.3.9: 172.16.3.50."
addr1:subnet – It means the subnet address with start IP address.
Please type the subnet and the IP address, for example, "-l
172.16.3.9:255.255.0.0".0
any – It means Any address. Simple type "-l" to specify any address
for this command.
Specify the ID.
Specify the service type by typing the number. The available types
are listed as below:
815