Draytek Vigor2860 User Manual page 119

SIM PIN code
Modem Initial String
APN Name
Modem Initial String2
Modem Dial String
Service Name
PPP Username
PPP Password
PPP Authentication
Index (1-15) in Schedule
Setup
WAN Connection
Detection
Vigor2860 Series User's Guide
adjusted in this page will be invalid.
Type PIN code of the SIM card that will be used to access
Internet.
The maximum length of the PIN code you can set is 15
characters.
Such value is used to initialize USB modem. Please use the
default value. If you have any question, please contact to
your ISP.
The maximum length of the string you can set is 47
characters.
APN means Access Point Name which is provided and
required by some ISPs. Type the name and click Apply.
The maximum length of the name you can set is 43
characters.
The initial string 1 is shared with APN.
In some cases, user may need another initial AT command to
restrict 3G band or do any special settings.
The maximum length of the string you can set is 47
characters.
Such value is used to dial through USB mode. Please use the
default value. If you have any question, please contact to
your ISP.
The maximum length of the string you can set is 31
characters.
Enter the description of the specific network service.
Type the PPP username (optional). The maximum length of
the name you can set is 63 characters.
Type the PPP password (optional). The maximum length of
the password you can set is 62 characters.
Select PAP only or PAP or CHAP for PPP.
You can type in four sets of time schedule for your request.
All the schedules can be set previously in Application >>
Schedule web page and you can use the number that you
have set in that web page
Such function allows you to verify whether network
connection is alive or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection. If you choose Ping Detect as the
detection mode, you have to type required settings for the
following items.

Primary/Secondary Ping IP – If you choose Ping Detect as
detection mode, you have to type Primary or Secondary IP
address in this field for pinging.

Ping Gateway IP – If you choose Ping Detect as detection
mode, you also can enable this setting to use current WAN
gateway IP address for pinging.
With the IP address(es) pinging, Vigor router can check if
the WAN connection is on or off.

TTL (Time to Live) – Set TTL value of PING operation.

Ping Interval – Type the interval for the system to
105