Draytek Vigor2860 User Manual page 83

Available settings are explained as follows:
Item
Load Balance Mode
Index
Enable
Physical Mode / Type
Line Speed(Kbps)
DownLink/UpLink
Active Mode
Info
After finished the above settings, click OK to save the settings.
Vigor2860 Series User's Guide
Description
This option is available for multiple-WAN for getting enough
bandwidth for each WAN port. If you know the practical
bandwidth for your WAN interface, please choose the setting
of According to Line Speed. Otherwise, please choose Auto
Weight to let the router reach the best load balance.
IP Based - The same source / destination IP pair will select
the same WAN interface as policy. It is the default setting.
Sesseion Based- All of the WAN interfaces will be used (as
out-going WAN) for passing through new sessions to get
better transmission speed. Though good speed test result for
throughput might be reached; however, some web site may
not open smoothly, especially the site need authentication,
e.g., FTP.
If you have no strong demand about speed test result, keep
default settings as IP based.
Click the WAN interface link under Index to access into the
WAN configuration page.
V means such WAN interface is enabled and ready to be used.
Display the physical mode and physical type of such WAN
interface.
Display the downstream and upstream rate of such WAN
interface.
Display whether such WAN interface is Active device or
backup device.
Backup (WAN#) - Display the backup WAN interface for such
WAN when it is disabled.
In default, each WAN port is enabled.
69