Draytek Vigor2860 User Manual page 898

backup_wait
pipe
wakeup [on/off]
vid
pid
status
E x a m p l
E x a m p
> wan modem pin 0000
> wan modem status
Modem Link Speed=0
Current Signal Strength=0
Last Fail Message:
Current Connect Stage:
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure display current VDSL status and configure the fallback
mode for WAN connection.
S y n t a x
S y n t a x
wan vdsl [show basic]
wan vdsl[fbk_mode]
S y n t a x
S y n t a x
Parameter
show basic
fbk_mode
E E x x a a m m p p l
> wan vdsl show basic
ADSL
Link Status:
Firmware Version:
ADSL Profile:
Basic
884
on: None.
off: PAP or CHAP.
Set waiting time after boot if USB WAN is in backup mode. This
waiting time is reserved for the dial of main WANs so that the
backup USB WAN will not go up first.
Available setting is from 1 to 255. Unit is second.
It is for RD debug only. Please don't use it without our advice.
It is for RD debug only. Please don't use it without our advice.
Set VID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
Set PID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
Display current status of USB modem.
e
l e
a n d : w a n v d s l
a n d : w a n v d s l
D e s c r i p t i o n
D e s c r i p t i o n
Description
It means to display current VDSL status.
It means to display current status of Fallback Mode used.
Available modes to be set as fallback mode include,
Auto
Vdsl_only
Adsl_only
l e e
TRAINING
Status Upstream
05-04-04-04-00-01
Downstream Unit
Vigor2860 Series User's Guide