Omron VARISPEED E7 User Manual page 248

Comparing Inverter Parameters and Digital Operator Parameter Set Values (VERIFY)
To compare Inverter parameters and Digital Operator parameter set values, use the following method.
Step
Digital Operator Display
No.
1
2
3
4
5
6
7
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Error displays
and their meanings are shown below. (Refer to
Function.)
Error Display
Verify error (Settings in the Digital Operator and the Inverter do not match).
Application Precautions
When using the copy function, check that the following settings are the same between the Inverter and the
Digital Operator.
• Inverter product and type
INFO
• Software number
• Inverter capacity and voltage
Press the MENU key. and select advanced program-
ming mode.
Press the DATA/ENTER key to enter the parameters
monitor display.
Select parameter o3-01 (Copy Function Selection)
using the Increment key and Decrement key.
Press the DATA/ENTER key to enter the function set-
ting display.
Change the set value to 3 using the Increment key.
Press the DATA/ENTER key. The VERIFY function
will start.
If the VERIFY function ends normally, "End" is dis-
played on the Digital Operator. Parameter
o3-01 is automatically reset to 0, and then the display
returns to o3-01.
Chapter 7, Errors when Using the Digital Operator Copy
Meaning
Explanation
6
109
6-