Omron VARISPEED E7 User Manual page 246

Storing Inverter set values in the Digital Operator (READ)
To store Inverter set values in the Digital Operator use the following method.
Step
Digital Operator Display
No.
1
2
3
4
5
6
7
If an error is displayed, press any key to cancel the error display and return to the o3-01 display. Error displays
and their meanings are shown below. (Refer to
Function.)
Error Display
You are attempting to set o3-01 to 1 while o3-02 is set to 0.
Read data length mismatch or read data error.
Tried to write parameters to EEPROM on the Digital Operator, but unable to perform write operation.
Select READ Prohibited
This function prevents overwriting of the data that are stored in the EEPROM of the Digital Operator. When
o3-02 is set to 0 and o3-01 is set to 1 to perform a write operation, PrE will be displayed on the Digital Opera-
tor and the write operation will be stopped.
Press the MENU key, and select advanced program-
ming mode.
Press the DATA/ENTER key to enter programming
mode.
Select parameter o3-01 (Copy Function Selection)
using the Increment key and Decrement key.
Press the DATA/ENTER key to enter the parameters
setting display.
Change the set value to 1 using the Increment key.
Press the DATA/ENTER key. The READ function
will start.
If the READ function ends normally, "End" is dis-
played on the Digital Operator. Parameter o3-01 is
automatically reset to 0, and then the display returns
to o3-01.
Chapter 7, Errors when Using the Digital Operator Copy
Meaning
Explanation
6
107
6-